A pump for increasing the pressure 123Vt Hmax 9m Qmax 25l / min ؾ 160mm + nuts ؽ LEO 3.0 (774741) These pumps are designed for pumping and pressurizing the existing water supply system. They can be used to create a pressure front heaters, gas water heater, washing machines and dishwashers, as well as to increase the water pressure in the shower or other points of demand. Pumping Unit: - Body: cast iron; - Engine shaft: cermet based on aluminum oxide; - Impeller: technopolymer with heat resistance up to 150 ° C. Motor: - Motor type: asynchronous, low noise; - the stator windings of copper; - motor stator sleeve: Stainless steel AISI 304; - Bearings: cermet based on aluminum oxide; - Voltage: 220-240V; - Frequency: 50 Hz; - Insulation class: H; - Degree of protection: IP42; - Cable length: 1 m; - Flow sensor for auto on / off with a flow rate at the point of demand. Tube: - DN1: ¾ "; - re Thread
