The station consists of several structural elements: first of all, a pump that directly pumps water from wells, wells, open reservoirs. The next important part of the device is a storage tank for liquid - a hydraulic accumulator or a tank. The switching on and off of the pump is controlled by a relay, which, when the amount of water in the tank is low, starts the pumping system. Service, warranty, supply of spare parts. Pick up spare parts for the pumping station.
From a well or a well, the pump pumps water into the receiver. In the latter, the pressure set by the control unit is created, and the pump is turned off. Through the water supply system from the accumulator, water is supplied to the consumer. After the pressure in the storage tank drops to the lower level, the pump turns on again.
The installation of a water supply station should take place in a warm season to avoid problems associated with freezing of water in the system. Also, a prerequisite is the presence of a 220V electrical network with a grounded outlet, and the depth of water intake (meters to water from the pump-suction line) from a well or well should not be more than 6 meters.
To assemble a system to provide a house with water, you need: the water supply station itself, a pair of check valves, a hose for taking water from the well and protection against "dry" running. The hose must be at least an inch in diameter. The “Suction Kit” is a complete set of hose, fittings and check valve. They are distinguished only by the length of the hose and the material of the connectors (brass or plastic). If the components are purchased separately, then the installation of the water supply station must begin with the water suction unit.
When installing the casing in the well, the submersible pump of the water supply system is fixed on a cable in the middle part of the water column closer to the bottom. To prevent solid particles from entering the water intake system, a protective mesh is installed on the hose in the well. A filter must also be installed at the pump inlet.
